After removal and steering installation the hydraulic system should be again filled with liquid, and it is necessary to remove air from it. Do not fill in in hydraulic system the liquid which has flowed out at removal of the steering mechanism. Air from hydraulic system of a steering is removed independently after the engine will work some time. Observe the following sequence:

Fig. 267. Uncover a tank of the hydraulic booster of a steering and shchupy check level of hydraulic liquid (щуп it is located on a cover)

- the cover of the tank has щуп. If the system cold, liquid has to settle down within a zone designated by a label of "Kalt" if liquid has working temperature, its level should be in zone "Warm" limits (see fig. 267 );

- at the switched-off engine check level of hydraulic liquid;

- in case of need add hydraulic liquid. At the working engine in liquid it should not be visible any vials of air;

- get the engine and slowly rotate a steering wheel at first in one, and then in other party;

- in case of need add hydraulic liquid.